How to Fix a Broken Tile in Your Kitchen

Whether your kitchen floor is new or old, there's nothing that disturbs the balance of a room quite like a broken tile. After all, tiles were installed with a pattern in mind: break one link in the chain and the whole thing falls apart. That's why it's important to know how to fix a broken tile - like learning how to change a tire, sometime it pays to know how before you have to do it.

First, we can assume that the conjoining material between each tile is already hard, which means that you'll have to do a little work that might include dust and debris. Make sure to wear protective eye goggles - you might even want to cover your mouth to prevent inhaling too much dust into your lungs.

Next, you'll have to destroy and remove any leftover spots from the previous tile. Most likely your tile is still in place, unless the whole tile itself came out already. In order to remove tile chips, you're going to want to follow a precise pattern: break the tile in the center using a hammer and nailset, and then cut the tile into an X pattern using a glass cutter. Then you can use the hammer to chip away the rest of the tile - beginning in the center - and pry up the pieces using a metal tool.

Once the area is cleared of the main tile bits, it's time for you to dry it out - suck out the remaining debris with a vacuum cleaner. It might not hurt to sand down any protruding areas that might get in the way for the new tile, so be sure to vacuum after you've done the sanding, as well.

Now that you have a clear area where your tile used to be, it's time to replace the tile. First you're going to want to fill the area with latex primer and allow it to dry - you should probably make sure to protect this area so that no one steps in it, particularly small children if you have them. After the primer has dried, you can apply tile adhesive, making sure to move it left and right to make sure it settles in properly. It's important to keep the tile level, so use a mallet to make sure that it gets in far enough. Any extra tile adhesive that comes out of the sides can be scooped up with a stick or screwdriver.

Give the tile some time to dry and you should be all finished. You've covered up the spot in your kitchen that detracted from all the rest. Now if you could just get a new set of cupboards.

Photo Credits: wakingphotolife

This post involves:

chips, debris, eye goggles, glass cutter, hammer, how to change a tire, kitchen floor, latex, lungs, mallet, metal tool, nailset, precise pattern, protective eye, tile adhesive, tiles, vacuum cleaner

... and focuses on:

Floors, Handyman, How to Fix, kitchen

Posted by Fix Handyman on August 4, 2009 in Floors, Handyman, How to Fix, kitchen. You can skip to the end and leave a response. Pinging is currently not allowed.